Pembuatan dan Karakterisasi Sensor Amonia Berbasis Bending Fiber Optic

chandra pratiwi, Gandi Sugandi, Junaidi Junaidi


This research was approved optical fiber bending sensors with good characterization and variations in the concentration of ammonia solution. This research uses experimental methods in the laboratory. The technique was done by stripping multimode optical fibers (cladding measuring 125 μm and core 62 μm) which is exfoliated cladding then replaced by polydimethylsiloxane (PDMS) and bending with the combustion process. The concentration of ammonia solution used in this research varies from 1-10%. Measurement of fiber optic sensors using optical power meter (OPM) with a wavelength of 1310 nm and 1550 nm, and light source (LS) at a frequency of 0 Hz, 270 Hz, 1000 Hz, and 2000 Hz. The result showed that ammonia solution caused instability in light intensity. However, the higher the frequency of light. The lower of the intensity with the difference in intensity produced is very small.

Keywords: ammonia, bending, cladding, optical fiber, polydimethylsiloxane (PDMS).



Article Metrics

Abstract view : 397 times
PDF - 193 times

Full Text:



A. T. Indra and Harmadi, “Karakterisasi Sistem Sensor Serat Optik Berdasarkan Efek Gelombang Evanescent,” J. Fis. Unand, vol. 3, no. 1, pp. 8–13, 2014.

A. Hanafiah, “Teknologi serat optik,” Staf Pengajar Dep. Tek. Elektro. Fak. Tek. USU, no. January 2006, pp. 87–91, 2013.

I.B.A. Pramarata, N. Wendri, “Rugi-rugi Serat Optik Berdasarkan Efek Gelombang Evanescent,” Universitas Udayana.

A. Ardi, A. N. Fauza, N. Syakir, and A. S. Kartasasmita, “Stabilitas Optik Polydimethylsiloxane ( PDMS ) Terhadap Paparan Sinar Ultraviolet,” Mater. dan Energi Indones., vol. 08, no. 01, pp. 16–21, 2018.

Anonim, “Optikal power meter,” 2016. [Online]. Available: meter.html. [Accessed: 25-Feb-2017].


This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.