Pengaruh Laju Penginjeksian Doping Sulfur terhadap Aktivitas Fotokatalis Nanotitania Menggunakan Metode Sol Gel

Delfi Oktavia Amrani, Posman Manurung, Pulung Karo Karo

Abstract


Abstract. Synthesis of sulfur doped titania (S-TiO2) was carried out through sol-gel method. Titanium isopropoxide (TTIP), tween-80, isopropanol and sulfuric acid (H2SO4) as a source of sulfur doping were used as raw material. The aimed of this research is to study the effect of the rate of sulfur doping injection by using an injection pump toward S-TiO2 photocatalyst activity. Four sulfur doping samples were prepared with rate injection of 4 ml/30; 4 ml/60; 4 ml/90 and 4 ml/120 minutes respectively. Titania powder was calcined at temperatur of 450 oC for 5 hours. The sintered samples were tested for photodegradation of remazol yellow under UV irradiation. Physical characteristics were analyzed using transmission electron microscopy (TEM) and UV-Vis Spectrophotometer. The result of the UV-Vis spectrophotometer showed that sample with an injection rate of 4 ml/30 minutes showed higer photocatalyst activity with the particle size is (7,1 nm ± 1,9 nm)


Keywords


photodegradation, remazol yellow, sulfur doped, titania.

Full Text:

PDF

References


D. R. Tobergte and S. Curtis, “Sintesis dan Karakterisasi Superkapasitor Berbasis Nanokomposit TiO2/C”, J. Chem. Inf. Model., vol. 53, no. 9, pp. 1689–1699, 2013.

K. Thamaphat, P. Limsuwan, and B. Ngotawornchai, “TiO2 XRD Pattern”, vol. 361, pp. 357–361, 2008.

N. T. Nolan, M. K. Seery, and S. C. Pillai, “Spectroscopic investigation of the anatase-to-rutile transformation of sol-gel-synthesized TiO2 photocatalysts”, J. Phys. Chem. C, vol. 113, no. 36, pp. 16151–16157, 2009.

K. Nishizawa, M. Okada, and E. Watanabe, “New Preparation Method of Visible Light Responsive Titanium Dioxide Photocatalytic Films”, Mater. Sci. Appl., vol. 05, no. 03, pp. 112–123, 2014.

R. K. Wahi et al., “Photodegradation of Congo Red catalyzed by nanosized TiO2”, J. Mol. Catal. A Chem., vol. 242, no. 1–2, pp. 48–56, 2005.

E. M. Rockafellow, L. K. Stewart, and W. S. Jenks, “Is sulfur-doped TiO2 an effective visible light photocatalyst for remediation?”, Appl. Catal. B Environ., vol. 91, no. 1–2, pp. 554–562, 2009.

M. Stucchi et al., “Surface decoration of commercial micro-sized TiO2 by means of high energy ultrasound: A way to enhance its photocatalytic activity under visible light”, Appl. Catal. B Environ., vol. 178, pp. 124–132, 2014.

M. Pelaez et al., “A review on the visible light active titanium dioxide photocatalysts for environmental applications”, Appl. Catal. B Environ., vol. 125, pp. 331–349, 2012.

K. J. A. Raj and B. Viswanathan, “Effect of surface area, pore volume and particle size of P25 titania on the phase transformation of anatase to rutile”, Indian J. Chem. - Sect. A Inorganic, Phys. Theor. Anal. Chem., vol. 48, no. 10, pp. 1378–1382, 2009.

L. Mao, Q. Li, H. Dang, and Z. Zhang, “Synthesis of nanocrystalline TiO2 with high photoactivity and large specific surface area by sol-gel method”, Mater. Res. Bull., vol. 40, no. 2, pp. 201–208, 2005.

W. Yu et al., “Enhanced visible light photocatalytic degradation of methylene blueby F-doped TiO2”, Appl. Surf. Sci., vol. 319, no. 1, pp. 107–112, 2014.

M. Hamadanian, A. Reisi-Vanani, and A. Majedi, “Preparation and characterization of S-doped TiO2 nanoparticles, effect of calcination temperature and evaluation of photocatalytic activity”, Mater. Chem. Phys., vol. 116, no. 2–3, pp. 376–382, 2009.

S. Fadilah, P. Manurung, and E. Ginting, “Pengaruh titania yang didoping sulfur terhadap ukuran partikel”, vol. 04, no. 01, pp. 37–42, 2016.

T. Ohno, T. Mitsui, and M. Matsumura, “Photocatalytic Activity of S-doped TiO2 Photocatalyst under Visible Light”, Chem. Lett., vol. 32, no. 4, pp. 364–365, 2003.

U. Diebold, “The surface science of titanium dioxide”, vol. 48, no. x, 2002.




DOI: http://dx.doi.org/10.23960%2Fjtaf.v7i2.2246

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.